Selecting Units Of Measurement - Furuno GP-150 Installation Manual

8. MENU SETTINGS
Entering position
After the unit is installed you may enter
position to shorten the time it takes to find
position. (It takes about two minutes when
there is no position data entered.)
1) Press MENU ESC, 9 and 6.
2) Press or to select Posn on page
2/2.
3) If necessary, press
north latitude to south latitude or vice
versa. Key in latitude.
4) If necessary, press
east longitude to west longitude or vice
versa. Key in longitude.
5) Press the NU/CU ENT key.
6) Press the MENU ESC key.
8.2 Selecting Units of
Measurement
Unit of distance
Distance can be displayed in nautical mile,
kilometer or statute mile as follows.
1) Press MENU ESC, 9 and 2. The UNIT
SETUP menu appears.
UNIT SETUP
Unit of Distance
Unit of Depth
Unit of Temp.
Unit of Altitude
:Select
ENT : Enter
Figure 8-3 UNIT SETUP menu
2) Press or to select Unit of
Distance.
3) Press or to select unit; nm, km or
sm.
4) Press the NU/CU ENT key.
5) Press the MENU ESC key.
8-4
to switch from
to switch from
nm km sm
m ft FA
C
F
m
ft
MENU : Escape
Unit of depth
1) Press MENU ESC, 9 and 2.
2) Press or to select Unit of Depth.
3) Press or to select unit; meter, feet,
or fathom.
4) Press the NU/CU ENT key.
5) Press the MENU ESC key.
Unit of water temperature
1) Press MENU ESC, 9 and 2.
2) Press or to select Unit of Temp.
3) Press or to select unit; Centigrade
or Fahrenheit.
4) Press NU/CU ENT and MENU ESC.
Unit of altitude
Available only in 3D mode.
1) Press MENU ESC, 9 and 2.
2) Press or to select Unit of Altitude.
3) Press or to select unit.
4) Press the NU/CU ENT key.
5) Press the MENU ESC key.