Call Waiting; Mute; Temporary Tone Dialing - AT&T 1070 User Manual

7
Telephone operation
Basic phone operation

Call waiting

If you subscribe to call waiting service with your
local telephone company, there will be a beep if
there is an incoming call when you are already on
a call on the same line.
1. Press [FLASH] to put your current call on hold
and take the new call.
2. Press [FLASH] anytime to switch back and forth
between calls. For more information on caller
ID with call waiting, see page 57.

MUTE

During a telephone conversation, press [MUTE] to
silence the microphone. You will be able to hear the
other party, but the other party will not be able to
hear you until you press [MUTE] again and resume
speaking. Mute is automatically cancelled when you
end a call.
When mute is active, the MUTE light will be on.
NOTE: Switching from handset to speakerphone
or headset, or from speakerphone or headset to
handset, changing lines, or putting a call on hold
also cancels the mute function.

Temporary tone dialing

If you have dial pulse (rotary) service only, you
can temporarily switch dial pulse to touch-tone
dialing during a call by pressing [*TONE].
1. Dial the number.
2. Press and release [*TONE]. Buttons pressed
after this send touch-tone signals.
3. After you hang up, the phone automatically
returns to pulse dial mode.
19