Telephone operation
Handset operation
Volume control
While on a call, press
to increase the listening volume. You
six levels.
Call waiting
If you subscribe to call waiting service from your telephone service provider,
and someone calls while you are already on a call, you hear two beeps. Press
FLASH to put your current call on hold and take the new call.
PHONE/
FLASH at any time to switch back and forth between calls.
Press
PHONE/
Mute
The mute function allows you to hear the other party, but the other party
cannot hear you.
Press MUTE/
DELETE
Handset locator
Use this feature to find misplaced handsets.
To start the paging tone:
HANDSET LOCATOR on the telephone base to start the paging
•
Press
/
tone on all handsets for 60 seconds.
NOTE: If you press
handset stops, but the paging to the rest of the handsets continues.
To stop the paging tone:
•
Press
PHONE/
on the handset(s).
-OR-
HANDSET LOCATOR on the telephone base.
•
Press
/
Join a call in progress
When a handset is already on a call and you would like to join the call, press
PHONE/
FLASH
OFF/
Press
CANCEL
end the call. The call does not end until all handsets hang up.
NOTE: You can use a maximum of 4 system handsets at the same time on an outside call.
/VOLUME to decrease or press
qCID
while on a call to enable or disable the mute feature.
OFF/
CANCEL
,
/SPEA�ER
SPEA�ER, or any dialing key (0-9, TONE , or #)
FLASH
/SPEA�ER
SPEA�ER on your handset.
or
or place the handset in the telephone base or charger to
can set the listening volume to one of
or MUTE/
on a handset, the ringer of that
DELETE
11
/VOLUME
pDIR