Figure 36-1 Menu 24.11 - Remote Management Control; Table 36-1 Menu 24.11 - Remote Management Control - ZyXEL Communications ZyWall 10 User Manual

ZyWALL 10~100 Series Internet Security Gateway
To disable remote management of a service, select Disable in the corresponding Server Access field.
Enter 11 from menu 24 to bring up Menu 24.11 – Remote Management Control.
TELNET Server:
FTP Server:
Web Server:
SNMP Service:
DNS Service:
The following table describes the fields in this screen.
Table 36-1 Menu 24.11 – Remote Management Control
FIELD
Telnet Server Each of these read-only labels denotes a service that you may use to
FTP Server remotely manage the ZyWALL.
Web Server
SNMP Service
DNS Service
Server Port This field shows the port number for the remote management service.
You may change the port number for a service if needed, but you must
use the same port number to use that service for remote management.
Server Access Select the access interface (if any) by pressing [SPACE BAR], then
[ENTER] to choose from: LAN only, WAN only, ALL or Disable.
Secured Client The default 0.0.0.0 allows any client to use this service to remotely
IP manage the ZyWALL. Enter an IP address to restrict access to a client
with a matching IP address.
Once you have filled in this menu, press [ENTER] at the message "Press ENTER to Confirm or ESC to
Cancel" to save your configuration, or press [ESC] to cancel.
36-2
Menu 24.11 - Remote Management Control
Port = 23
Secured Client IP = 0.0.0.0
Port = 21
Secured Client IP = 0.0.0.0
Port = 80
Secured Client IP = 0.0.0.0
Port = 161
Secured Client IP = 0.0.0.0
Port = 53
Secured Client IP = 0.0.0.0
Press ENTER to Confirm or ESC to Cancel:
Figure 36-1 Menu 24.11 – Remote Management Control
Access = LAN only
Access = LAN only
Access = LAN only
Access = LAN only
Access = LAN only
DESCRIPTION EXAMPLE
23
LAN Only
(default)
0.0.0.0
Remote Management