This chapter describes how to access the ZyWALL web configurator and provides an overview of
2.1
Web Configurator Overview
The embedded web configurator allows you to manage the ZyWALL from anywhere through a browser such
as Microsoft Internet Explorer or Netscape Navigator. Use Internet Explorer 6.0 and later or Netscape
Navigator 7.0 and later versions with JavaScript enabled. It is recommended that you set your screen
resolution to 1024 by 768 pixels. The screens you see in the web configurator may vary somewhat from the
ones shown in this document due to differences between individual ZyWALL models or firmware versions.
2.2
Accessing the ZyWALL Web Configurator
Step 1.
Make sure your ZyWALL hardware is properly connected and prepare your
computer/computer network to connect to the ZyWALL (refer to the Quick Start Guide).
Step 2.
Launch your web browser.
Step 3.
Type "192.168.1.1" as the URL.
Step 4.
Type "1234" (default) as the password and click Login. In some versions, the default password
appears automatically - if this is the case, click Login.
Step 5.
You should see a screen asking you to change your password (highly recommended) as shown
next. Type a new password (and retype it to confirm) and click Apply or click Ignore.
Step 6.
You should now see the MAIN MENU screen (see Figure 2-3).
Introducing the Web Configurator
Introducing the Web Configurator
Figure 2-1 Change Password Screen
ZyWALL 10~100 Series Internet Security Gateway
Chapter 2
its screens.
2-1