3Com 4200G 12-Port Configuration Manual page 372

358 C 40: B ROM
HAPTER OOT
H S L
AND OST OFTWARE OADING
Figure 115 Sending file page
After the download completes, the system displays the following information:
Loading ...CCCCCCCCCC done!
You need not reset the HyperTerminal's baud rate and can skip the last step if you
have chosen 9600 bps. In this case, the system display the prompt "BootROM is
updating now.....................................done!" instead of the prompt "Your
baudrate should be set to 9600 bps again! Press enter key when ready".
9 Reset HyperTerminal's baud rate to 9600 bps (refer to step 4 and step 5). Then, press
any key as prompted. The system will display the following information when it
completes the loading.
Bootrom updating.....................................done!
Loading host software
Follow these steps to load the host software:
1 Select <1> in Boot Menu. The system displays the following information:
1. Set TFTP protocol parameter
2. Set FTP protocol parameter
3. Set XMODEM protocol parameter
0. Return to boot menu
Enter your choice(0-3):3
2 Enter 3 in the above menu to download the host software using XMODEM.
The subsequent steps are the same as those for loading the BootROM software,
except that the system gives the prompt for host software loading instead of
BootROM loading.