3Com 4200G 12-Port Configuration Manual page 297

Network diagram
Figure 87 Network diagram for SNMP
10.10.10.1 10.10.10.1
N MS N MS
Network procedure
1 Set the community name, group name and user.
<S4200G> system-view
[4200G] snmp-agent sys-info version all
[4200G] snmp-agent community write public
[4200G] snmp-agent mib-view include internet 1.3.6.1
[4200G] snmp-agent group v3 managev3group write-view internet
[4200G] snmp-agent usm-user v3 managev3user managev3group
2 Set the VLAN interface 2 as the interface used by network management. Add port
GigabitEthernet1/0/2 to the VLAN 2. This port will be used for network management.
Set the IP address of VLAN interface 2 as 10.10.10.2.
[4200G] vlan 2
[4200G-vlan2] port GigabitEthernet 1/0/2
[4200G-vlan2] quit
[4200G] interface Vlan-interface 2
[4200G-Vlan-interface2] ip address 10.10.10.2 255.255.255.0
3 Enable the SNMP agent to send Trap packets to the NMS whose IP address is
10.10.10.1. The SNMP community is public.
[4200G] snmp-agent trap enable standard authentication
[4200G] snmp-agent trap enable standard coldstart
[4200G] snmp-agent trap enable standard linkup
[4200G] snmp-agent trap enable standard linkdown
[4200G] snmp-agent target-host trap address udp-domain 10.10.10.1
udp-port 5000 params securityname public
Configuring NMS
The Ethernet Switch supports 3Com's Quidview NMS. SNMP V3 adopts user name
and password authentication. In [ Quidview Authentication Parameter], you need to
set a user name, choose security level, and set authorization mode, authorization
password, encryption mode, encryption password respectively according to different
security levels. In addition, you must set timeout time and retry times.
Users can query and configure the Ethernet switch through the NMS. For more about
it, refer to the manuals of 3Com's NM products.
NM configuration must be consistent with device configuration; otherwise, you will
fail to perform the related operations.
SNMP Configuration Example 283
10.10.10 .2 10.10.10 .2
Ethernet Ethernet