3Com 3CR17660-91 Quick Reference Manual

3C S
OM WITCH
Q R
UICK EFERENCE
Overview
This Command Reference applies to the following Switch 4200G models:
Switch 4200G 12-Port (3CR17660-91)
Switch 4200G 24-Port (3CR17661-91)
About the Command Line Interface
To use and navigate the command line interface of your unit, please refer to the following points for assistance:
When initially accessing the command line interface, press Enter when prompted. The User View
■
displays. This is indicated by the chevron brackets around the name of the unit at the prompt, for example,
<sw4200G>.
When in the System View menu, square brackets appear around the name of the unit at the
■
[sw4200G].
You must be in the System View menu to access the configurable CLI commands.
■
Some commands can be entered directly at any prompt from anywhere in the interface.
■
If you enter part of a command followed by a ? (with no space between), the CLI will show you
■
that begin in that way.
The term 'view' may be used interchangeably with the term 'menu'.
■
c
The ommand is placed before the command you wish to undo, for example,
■
undo
<CTRL-A> places the cursor back to the start of the command line.
■
Enter the first few characters of a command and press TAB to enter the full command without
■
entire command (where there is only one command that starts with the entered characters).
Use the Up Arrow key at the prompt to repeat the previous command string.
■
Use the Delete key to delete the character after the cursor; the Backspace key deletes the character
■
When entering physical port numbers, Enter the port number as
■
physical port number.
Copyright © 2006, 3Com Corporation. All rights reserved.
www.3Com.com
Part Number: 10014917 Rev. AA
Published: July 2006
4200G F
AMILY
G
UIDE
Switch 4200G 48-Port FX (3CR17662-91)
Switch 4200G 1-Port 10Gigabit Module (XFP) (3C17666)
undo setauthentication
, where x is the unit
x/0/z
menu for the unit
prompt, for example,
all the commands
password.
having to input the
before the cursor.
number and z is the