Indicator Light Removal; Meat Probe Receptacle Replacement (Select Models); Back Panel Removal; Cooling Fan Replacement - Jenn-Air JES8750BA Series Service Manual

Disassembly Procedures

Indicator Light Removal

1. Remove control panel, see "Control Panel" procedure
for removal.
2. Label and disconnect wires from indicator light.
3. Squeeze the two tabs on the indicator light body and
gently pull to release from control panel.
4. Reverse procedure to reinstall indicator light.
Broil Element
Bake
Element
Meat Probe Receptacle Replacement
(Select Models)
1. Remove power from unit.
2. Remove range from installation position, see
"Removing and Replacing Range" procedure.
3. Remove front side trim, see "Front Side Trim
Removal" procedure.
4. Remove screws securing side panel to chassis and
main top.
5. Open oven door and remove nut securing meat probe
receptacle to oven cavity.
6. Label and disconnect wire terminals from receptacle.
7. Gently slide meat probe receptacle through oven
cavity.
8. Reverse procedure to reinstall meat probe receptacle.

Back Panel Removal

1. Remove power from unit.
2. Remove range from installation position, see
"Removing and Replacing Range" procedure.
3. Remove screws securing back panel to unit.
4. Slide back panel up and out to remove.
5. Reverse procedure to reinstall back panel.

Cooling Fan Replacement

1. Remove power from unit.
2. Remove range from installation position, see
"Removing and Replacing Range" procedure.
3. Remove back panel, see "Back Panel Removal"
procedure.
© 2006 Maytag Services
To avoid risk of electrical shock, personal injury or
death; disconnect power before servicing, unless
testing requires power.
4. Label and disconnect wire terminals from cooling fan.
5. Remove screws securing fan to range chassis.
6. Reverse procedure to reinstall cooling fan.
Hidden Bake Element Replacement
(Select Models)
1. Remove power from unit.
2. Open oven door and remove rack(s).
3. Remove screws securing hidden bake element cover.
Oven Sensor
4. Remove hidden bake element cover by sliding cover
Cooling
Fan
5. Remove screws securing bake element to rear of
6. Pull element forward to allow for labeling and
Transformer
7. Remove element support clips.
8. Reverse procedure to reinstall bake element.

Bake Element Replacement (Select Models)

Meat
1. Remove power from unit.
Probe
2. Open oven door and remove rack(s).
3. Remove screws securing bake element to rear of
4. Pull element forward to allow for labeling and
5. Remove element support clips.
6. Reverse procedure to reinstall bake element.

Broil Element Replacement

1. Remove power from unit.
2. Open oven door and remove racks.
3. Remove screws securing broil element to top and
4. Pull broil element forward to allow disconnection of
5. Reverse procedure to reinstall broil element.
Downdraft Blower Motor Removal
(Select Models)
1. Remove power from unit.
2. Remove bottom access panel, see "Bottom Access
3. Disconnect ducting to allow for downdraft blower
4. Label and disconnect wire terminals.
5. Remove screws securing motor assembly.
6. Reverse procedure to reinstall downdraft blower
16026926
toward the rear of the oven cavity while lifting up on
front of cover.
cavity wall.
disconnection of wire terminals.
cavity wall.
disconnection of wire terminals.
rear of oven cavity.
wiring from terminals.
Panel Removal" procedure.
motor removal.
motor (select models).
27