Troubleshooting; Error Messages - Toshiba e-STUDIO170F Owner's Manual

TROUBLESHOOTING

Error Messages

If an abnormal condition arises
in the facsimile or an incorrect
operation is performed, an
alarm buzzer is generated for
about 4 seconds and a mes-
BROKEN REGISTRATION
sage to indicate the nature of
the error appears in the LCD
window. In that case, take cor-
rective action according to the
following table.
POWER FAILURE
COVER OPEN
TONER NOT
RECOGNIZED
204
Error Message Cause / Solution
Autodialer numbers and initial set-
tings have been lost (due to a long
period without power or a deplet-
ed backup battery).
Press
state. If this Error Message is re-
peatedly displayed, machine pro-
gramming has become corrupted.
The machine must be re-initiatized
by a trained technician. Call for
service.
A power failure occurred during a
communication, etc. The contents
of memory were cleared due to a
long power-off condition.
A Power Failure List is printed.
Confirm the list contents (see
page 203).
A cover is open.
Firmly close all covers.
No Toner Cartridge and Drum Unit
exist.
Install the Toner Cartridge and
Drum Unit. If error message still
exists after installation, call for ser-
vice.
If you request our service techni-
cian to use a toner cartridge other
than that of our recommendation
(Page 27, 29:IMPORTANT),
please note that the message
"TONER NOT RECOGNIZED" will
continue to be displayed after ser-
vice setting is changed.
Error Message
MEMORY FULL
STOP
to restore the idle
JOB MEMORY FULL
MEMORY OVERFLOW
DOCUMENT JAM
PAPER SIZE ERROR OR
PAPER JAM XX
Cause / Solution
The memory set aside for
speed dial numbers (i.e. One
Touch Keys and Abbreviated
Dial Numbers) has been ex-
hausted.
Delete unneed numbers, alter-
nate numbers, and unnecessary
pauses. Use shorter names for
the dialing addresses.
The maximum number of manu-
ally input phone numbers (100)
has been reached.
Split your transmission into two
or more jobs.
There is not enough memory to
perform the requested opera-
tion.
STOP
Press to cancel the mes-
sage. Do the operation over
again with the Direct Document
Transmission, or do the opera-
tion again when enough residual
memory is regained.
A document jam has occurred.
Remove the jammed document
(see page 210).
A recording paper jam has oc-
curred or paper size is mis-
match.
Remove the jammed paper or
change the setting to select the
current paper size (see pages
21, 206, 211).