Enabling Or Disabling Send After Scan Temporarily - Toshiba e-STUDIO170F Owner's Manual

Enabling or Disabling Send after Scan Temporarily

If the Send After Scan Mode
1
Default Setting is set to "OFF",
this feature allows you enable
the Send After Scan mode for
a single transmission. Once
Load the document face down
that transmission is complete,
in the Document Support (see
the default status is regained.
page 82).
If you enable Send after Scan,
Adjust the resolution and con-
you will be given the opportuni-
trast if desired (see pages 83
ty to select "SEND SCANNED
and 84).
PAGES" or "CANCEL SEND-
ING."
Select "SEND SCANNED
PAGES" if you want the pages
scanned to memory (prior to
the Memory Full) to be trans-
mitted.
Select "CANCEL SENDING" if
you want to cancel that trans-
mission and try again later
when more memory is avail-
able or use a Direct TX opera-
tion.
NOTES:
• To change the default set-
ting of this function, refer
to page 148. The status
selection in this operation
will take precedence over
the default setting.
166
2
Load the Document
Press:
JAN-31 09:43 AM 100%
AUTO RECEIVE
SEND AFTER SCAN
2.OFF
1.ON
3
Display the SEND Select the Send
AFTER SCAN Menu After Scan Option
Select the desired Send After
Scan Option.
MENU
+ To enable Send After Scan,
press:
+
+
UPON MEMORY FULL
1.CANCEL SENDING
2.SEND SCANNED PAGES
+
Go to Step 4.
To disable Send After Scan,
press:
The following is displayed for 2
seconds.
COMPLETED
Go to Step 5.
4
Select the Memory
Full Option
Select the desired Memory Full
Option.
To cancel the pages that have
been scanned, press:
To send the pages that have
been scanned, press:
The following screen is dis-
played. You may dial the re-
mote facsimile for your com-
munication job. The display will
return to the Standby Mode in
about 60 seconds if no keys
are pressed.
JAN-31 09:43 AM 100%
ENTER TEL NUMBER