TANDBERG Gatekeeper User Manual page 81

TANDBERG Gatekeeper User Manual
14.3.6 CredentialAdd
xCommand CredentialAdd <username> <password>
Adds the given username and password to the local authentication database.
14.3.7 CredentialDelete
xCommand CredentialDelete <index>
Deletes the indexed credential.
14.3.8 DefaultLinksAdd
xCommand DefaultLinksAdd
Restores the factory default links for bandwidth control.
14.3.9 DefaultValuesSet
xCommand DefaultValuesSet Level <level>
Resets system parameters to default values. Level 1 will reset most parameters. There are
currently no level 2 parameters, so setting that level has the same effect as setting level 1. Level
3 resets all level 1 and 2 parameters as well as the following:
IP address, subnet mask, gateway and interface speed. The default IP address is
192.168.0.100.
COM port baud rate, speed, data bits, parity, stop bits
SNMP community name and host address
system name
password
option key
release key
Note that DefaltValuesSet will not add the links with which the system ships from the factory. Use
the DefaultLinksAdd command to do that. Certificates and policy files are not removed
14.3.10 DenyListAdd
xCommand DenyListAdd <denied alias>
Add an entry to the deny list. This is used by the registration restriction policy.
70