TANDBERG Gatekeeper User Manual page 69

TANDBERG Gatekeeper User Manual
14.2.4 Gatekeeper
Commands under the Gatekeeper node control aspects of the systems operation relating to its
operation as an H.323 gatekeeper.
xconfiguration Gatekeeper Alternates Monitor:
Controls whether or not alternate gatekeepers are periodically interrogated to ensure that they
are still functioning. Non-functional alternates will not receive Location Requests in order to
prevent delays during call setup.
xconfiguration Gatekeeper Alternates Alternate [1..5] Address:
Set the IP address of an alternate Gatekeeper. Up to 5 alternates may be configured. When the
Gatekeeper receives a Location Request, all alternates will also be queried.
xconfiguration Gatekeeper Alternates Alternate [1..5] Port:
Set the IP port of an alternate Gatekeeper. The default is 1719.
xconfiguration Gatekeeper AutoDiscovery:
xconfiguration Gatekeeper CallRouted:
operate in call routed mode. Defaults to off.
Specifies whether or not the Gatekeeper responds to gatekeeper discovery requests from
endpoints. The default is On.
xconfiguration Gatekeeper CallsToUnknownIPAddresses:
Specifies whether or not the Gatekeeper will attempt to call systems which are not registered
with it or one of its neighbor gatekeepers. It has three settings:
Direct: this setting will allow the endpoint to make the call to the unknown IP address without
querying any neighbors. The call setup would occur just as it would if the far end were registered
directly to the local system.
Indirect: upon receiving the call the Gatekeeper will query its neighbors for the remote address,
relying on the response from the neighbor to allow the ability for the call to be completed;
connecting through the routing rules as it would through the neighbor relationship.
Off: this will not allow any endpoint registered directly to the Gatekeeper to call an IP address of
any system not also registered directly to that Gatekeeper.
See 4 for further detail. The default is Indirect.
xconfiguration Gatekeeper CallTimeToLive:
Interval in seconds at which endpoints are polled to verify that they are still in a call. The default
is 120 seconds.
xconfiguration Gatekeeper DNSResolution Mode:
Determines whether or not DNS lookup of H.323 URI's is enabled on this system. The default is
On.
xconfiguration Gatekeeper Downspeed PerCall Mode:
58
<On/Off>
<On/Off>
<On/Off> Specifies whether the Gatekeeper should
<Off/Direct/Indirect>
<60..65534>
<On/Off>
<On/Off>
<IPAddr>
<IPAddr>