TANDBERG Gatekeeper User Manual page 71

TANDBERG Gatekeeper User Manual
14.2.5 HTTP/HTTPS
Command under the HTTP and HTTPS nodes control web access to the Gatekeeper.
xConfiguration HTTP Mode: <On/Off>
Enables/disables HTTP support. You must restart the system for changes to take effect. The
default is On.
xconfiguration HTTPS Mode:
Enables/disables HTTPS support. You must restart the system for changes to take effect. The
default is On. If web access is required, you are recommended to enable HTTPS and disable
HTTP for improved security.
14.2.6 IP
Configuration of IP related parameters. The TANDBERG Gatekeeper may be configured to use
either IPv4 or IPv6. When entering IPv4 addresses, dotted quad notation is used: 127.0.0.1, when
using IPv6 addresses are entered in colon hexadecimal form: 2001:db8::2AA:FF:FE9A:4CA2.
xConfiguration IPProtocol:
Selects whether the Gatekeeper is operating in IPv4, IPv6 or dual stack mode.
xconfiguration IP Address:
The IPv4 address of the system.
xconfiguration IP SubnetMask: <IPAddr>
The IPv4 subnet mask of the system.
xconfiguration IP Gateway:
The IPv4 gateway of the system.
xconfiguration IP V6 Address: <IPAddr>
The IPv6 address of the system.
xconfiguration IP V6 Gateway: <IPAddr>
The IPv6 gateway of the system.
All the IP commands listed above require a system restart before they take effect.
xconfiguration IP DNS Server [1..5] Address:
Sets the IP address of the DNS servers to be used when resolving domain names. Normally only
the first DNS server will be queried for address resolution. If it fails to respond, all DNS servers
will be queried. You must restart the system for changes to take effect.
xconfiguration IP DNS Domain Name:
When attempting to resolve a domain name which is not fully qualified, name will be appended
to the domain name before the query to the DNS server is executed.
60
<On/Off>
<Both/IPv4/IPv6>
<IPAddr>
<IPAddr>
<IPAddr>
<name>