TANDBERG Gatekeeper User Manual page 17

TANDBERG Gatekeeper User Manual
Welcome to
TANDBERG Gatekeeper Release N5.0
SW Release Date: 2006-06-15
OK
10. Login with username admin and your password.
11. Review other system settings. You may want to set the following:
(a) The name of the Gatekeeper. This is used to identify the Gatekeeper by the TAND-
BERG Management Suite. See the xConfiguration SystemUnit command in sec-
tion 14.2.18 for more information on setting the name.
(b) Automatic discovery. If you have multiple Gatekeepers in the same network you
may want to disable automatic discovery on some of them. See the xConfiguration
Gatekeeper AutoDiscovery command in section 14.2.4.
(c) The DNS server address and the domain name if the Gatekeeper will be con-
figured with hostnames instead of IP address or if URI dialing is required. See
xConfiguration IP DNS Server Address command in section 14.2.6 for more infor-
mation.
12. Reboot the Gatekeeper by typing the command xCommand boot to make your new settings
take effect.
13. Disconnect the serial cable.
NOTE To securely manage the Gatekeeper you should disable HTTP and Telnet, using the
encrypted HTTPS and SSH protocols instead. For increased security, disable HTTPS and SSH
as well, using the serial port to manage the system.
NOTE If you do not have an IP gateway, configure the Gatekeeper with an unused IP address
that is valid in your subnet.
6