Whirlpool Polara GR556LRK Service Manual page 56

14. Using a 1/8" allen wrench, loosen the
setscrews on the evaporator and con-
denser fan blades and remove the blades
from the fan motor shafts. IMPORTANT:
Note the position and orientation of the
blades before you remove them so that
you can reinstall them in the same way.
Also be sure to tighten the setscrews
against the flattened portion of each shaft.
Evaporator Fan
Setscrew
Condenser Fan
Setscrew
15. Remove the three mounting screws from
the evaporator & condenser fan motor and
remove the motor.
REASSEMBLY NOTES: When you reinstall
the evaporator & condenser fan motor and
reassemble the cooling module, make sure
that you:
• Route the fan motor leads through the
wire slot in the insulation block to the front
of the module (see the photo below).
Wire Slot
• Be sure to route the fan motor leads over
the bimetal leads.
Fan Motor
Leads
4-32
Motor Mounting
Screw (1 of 3)
Fan Motor Leads
Bimetal Leads