Entering Temporary Temperature Setpoints; Ending Temporary Temperature Setpoints - Johnson Controls T600HPN-4 Installation Instructions Manual

Table 4: Entering Permanent Temperature
Setpoints (Part 2 of 3)
Thermostat Description
Controller
Display
Press the NO key for all prompts until
the temperature setpoint prompt
Temperat
appears on the display (it may be the
set? Y/N
first prompt). Press the YES key to
enter the temperature setting menu.
Press the YES key to change the
Occupied cooling setpoint. Press the
Cooling
NO key to advance to the Occupied
set? Y/N
heating setpoint menu.
Press the UP/DOWN arrow keys to
set the temperature. Press the
Cooling
YES key to store the value and
75.0°F
advance to the next menu.
Press the YES key to change the
Occupied heating setpoint. Press the
Heating
NO key to advance to the
set? Y/N
Unoccupied cooling setpoint menu.
Press the UP/DOWN arrow keys to
set the temperature. Press the
Heating
YES key to store the value and
68.0°F
advance to the next menu.
Press the YES key to change the
Unoccupied cooling setpoint. Press
Unocc CL
the NO key to advance to the
set? Y/N
Unoccupied heating setpoint.
Press the UP/DOWN arrow keys to
set the temperature. Press the
Unocc CL
YES key to store the value and
80.0°F
advance to the next menu.
Press the YES key to change the
Unoccupied heating setpoint. Press
Unocc HT
the NO key to advance to the
set? Y/N
temperature display units.
Press the UP/DOWN arrow keys to
set the temperature. Press the
Unocc HT
YES key to store the value and
62.0°F
advance to the next menu.
T600HPx-4 and T600HPx-4+PIR Series Heat Pump Thermostat Controllers Installation Instructions
Table 4: Entering Permanent Temperature
Setpoints (Part 3 of 3)
Thermostat Description
Controller
Display
Press the YES key to set the display
units to °F or °C. Press the NO key to
°F/°C
advance to the temperature setpoint
set? Y/N
type menu.
Press the YES key to return to the
Status Display Menu or press the
Exit?
NO key to re-enter the temperature
Y/N
setting menu.

Entering Temporary Temperature Setpoints

The user can temporarily change the temperature
setpoints for the Occupied and Unoccupied heating
and cooling modes. To temporarily change the setpoint,
press the UP/DOWN arrow keys to change the
temporary setpoint for the current mode of operation.
Note: Whether the thermostat controller is heating or
cooling, the respective setpoint is temporarily adjusted.
To toggle between the temporary heating and cooling
setpoints, press the NO key while changing the
temporary setpoints.

Ending Temporary Temperature Setpoints

The temporary setpoints remain in effect for the
duration set in the TOccTime parameter or until
manually released.
Note: Setting the TOccTime parameter to 0.0 hrs
prevents the temporary setpoints from taking effect.
To manually release the temporary setpoint, while in
the Main User Menu:
1. Press the NO key for all prompts until the Temperat
set prompt appears. If the thermostat controller is
in the Occupied state, this is the first prompt.
2. Press the YES key to cancel all temporary
setpoints.
3. Press the MENU key again and press the YES key
to exit the Main User Menu.
The setpoint reverts to the Permanent Temperature
Setpoint.
15