Setting Schedule Hold; Repair Information - Johnson Controls T600HPN-4 Installation Instructions Manual

5. Press the UP/DOWN arrow keys to adjust the day.
When the correct day is displayed, press the
YES key to store the day.
6. Press the YES key to choose the time format or
press the NO key to access the Main User Menu
exit prompt.
7. Press the UP/DOWN arrow keys to select the
desired time format. Press the YES key to enter
the format.
8. Press the YES key to return to the Status Display
Menu or press the NO key to return to the time set
menu.
When the thermostat controller scrolls through the day
and time, the new day and time should show on the
display and no alarm or backlight should be present. If
the day or time is incorrect, repeat the Setting the Day
and Time (T600HPP-4 and T600HPP-4+PIR Models)
procedure.

Setting Schedule Hold

The schedule hold menu is used to set a permanent
hold on the internal scheduling or resume the
schedule. The permanent hold is typically used for
non-scheduled events that extend for long periods of
time.
Note: The Override Schedule function is available on
the T600HPN-4 and T600HPN-4+PIR models only if
DI1 or DI2 is configured for remote NSB.
Note: The Schedule Hold menu is also displayed if
DI1 or DI2 is configured for remote NSB.
The following selections are available in the schedule
hold menu:
• Permanent Occupied Hold (occ hold): This
selection puts the thermostat controller into a
permanent Occupied state via the Occupied
setpoints. Occupied hold appears in the Status
Display Menu when this selection is active.
T600HPx-4 and T600HPx-4+PIR Series Heat Pump Thermostat Controllers Installation Instructions
• Permanent Unoccupied Hold: This selection puts
the thermostat controller into a permanent
Unoccupied state via the Unoccupied setpoints.
Unoccup hold appears in the Status Display Menu
when this selection is active.
• Resume: This selection cancels the permanent
hold and enables the regular program schedule.
To enable or cancel the permanent hold feature while in
the Main User Menu:
1. Press the NO key for all prompts until the schedule
hold prompt appears on the display. Press the
YES key to set the schedule hold type.
2. Press the UP/DOWN arrow keys to locate the
desired permanent hold type (or resume schedule).
Press the YES key to enter the selection.
3. Press the YES key to return to the Status Display
Menu or press the NO key to change the schedule
hold selection again.
Accessories
All the accessories in Table 8 include mounting
hardware; contact the nearest Johnson Controls®
representative to order any of these parts.
Note: Review the technical specifications of the
accessories prior to their use in an application.

Repair Information

If the T600HPx-4 or T600HPx-4+PIR Series
Thermostat Controller fails to operate within its
specifications, replace the unit. For a replacement
thermostat controller, contact the nearest
Johnson Controls representative.
19