Mercedes-Benz COMAND control unit Operator's Manual page 90

Traffic Messages
88
Symbol Description
Traffic jam
on route
Blocked
section on
route
Traffic jam
(stop and go)
(yellow car)
Traffic jam
(red car)
XXXX Blocked
section
Displaying Real-Time Traffic Reports
X
If necessary, switch to navigation mode
and show the menu system (
X
Select Traffic.
COMAND searches for SatRadio channels
sending traffic messages. You will see a
dialogue box displaying the message No
Traffic Messages.
This either means:
Messages were not yet received
R
there are no messages available
R
X
To cancel the search: Select Cancel.
X
To close the message: Select OK
Traffic Notifications in Map Display Traffic
Appears at the beginning of traffic
congestion from the driver's point of
view if route guidance is active and
route goes through congested area.
Red car symbols could appear in
combination with this symbol.
Appears at the beginning of a blocked
area from the driver's point of view if
route guidance is active and route
goes through blocked area.
XX XX symbols could appear in
combination with this symbol.
Traffic congestion, average speed
25 – 45 mph.
Could appear repeatedly to indicate
length of traffic congestion.
Traffic congestion, average speed
5 – 20 mph.
Could appear repeatedly to indicate
length of traffic congestion.
Road impassable.
Could appear repeatedly to indicate
length of blocked area
If there are traffic reports, you will see a list.
The content of the list varies depending on
whether route guidance is active or not.
Y page 54).
List When Route Guidance is not Active
The list shows all the roads, areas or regions
for which messages are available.
Traffic
Report Report
Lists Message
Appears Appears
with Traffic with
jam on Traffic
route entry jam on
type route
entry type
Appears Appears
with with
Blocked Blocked
section section
entry type entry type
(Not (Not
possible) possible)
(Not (Not
possible) possible)
(Not (Not
possible) possible)