Mercedes-Benz COMAND control unit Operator's Manual page 196

Navigation
194
s No
t Do you want to save the destination?
s Yes
The dialog continues as shown in the section
"Save destination".
"Last Destinations"
You can use the "Last destinations"
command to reselect a destination from a list
of the previously selected destinations.
Example of dialog:
s Last destinations
u The system shows a numbered list of
the previously selected destinations
t Please select a line number.
s Line number 1 ...
u Line number one accepted. Would you
like to start route guidance?
s Yes
The route guidance for this destination is
started.
"Save Destination"
You can use the "Save destination" command
to save the current destination in the address
book by means of a voice tag.
i If the desired voice tag already exists in
the address book, the system asks if you
want to add the address.
Example of dialog:
s Save destination
t Please say the name.
s Smith
t Please repeat the name.
s Smith
t Where would you like to save: home or
work?
s Work
t The destination has been saved.
The route guidance for this destination is
started.
"Find Address"
You can use the "Find address" command to
select a previously saved address and start
route guidance.
Example of dialog:
s Find address
t Please say the name.
s Smith
u The system shows a numbered list of
saved addresses in the display
t Please select a line number.
s Line number 1 ...
t Line number 1 accepted.
t Starting route guidance
"Start Route Guidance"
When Route Guidance is inactive, you can use
the "Start route guidance" command to start
route guidance once a valid destination has
been entered.
s Start route guidance
t Starting route guidance
"Route Information"
You can use the "Route information"
command to have the following information
on your currently planned route read out:
Distance to destination
R
Remaining driving time
R
Expected arrival time
R
"Guidance Instructions On"
When you use the "Guidance instructions on"
command, voice control repeats the last
driving tip. If the driving tip output has been
switched off up to this point, it is now
switched on again.
"Guidance Instructions Off"
You can use this command to switch off the
route guidance voice output.