Mercedes-Benz COMAND control unit Operator's Manual page 71

X
Select Yes or No.
If you select Yes COMAND cancels route
guidance and starts the route calculation to
the newly entered destination.
If you select No COMAND resumes the
active route guidance.
During the route calculation, an arrow
points towards the destination, and
underneath the message Calculating
Route..., for example, is displayed.
Route guidance begins after the route has
been calculated ( Y
i Route calculation takes some time. The
length of time depends on, e.g. distance to
the destination. COMAND calculates the
route using the digital map data. The
calculated route may deviate from the
actual road situation, e.g. as a result of road
works or incomplete map data. Please refer
to the information on the digital map
( Y page 59).
Entering a Destination from the
Destination Memory
X
If necessary switch to navigation mode and
display menu system (
X
Select Destination£From Memory.
If there are more than 8 entries in the
destination memory, the destination
memory list with predictive speller is
displayed, otherwise the destination
memory list is displayed without predictive
speller ( Y page 70).
i
There is always an entry in the destination
memory with the name MyAddress. You
can assign your home address, for
example, to this entry and select it for route
guidance ( Y page 90). This entry is at the
top of the list in the destination memory.
page 80).
Y page 54).
Destination Input
Destination Memory List with
Predictive Speller
If this list is given in the display, the predictive
speller 4 is activated automatically.
Character entered by the user
1
Characters added by the system
2
List entry that best matches the
3
characters already entered
Switches to list without speller
4
Press and hold deletes complete entry,
5
press briefly deletes last character
Currently unavailable characters
6
Currently available characters
7
Predictive speller
8
Currently selected character
9
Cancels an entry
a
Destination memory list
b
i In the predictive speller 8 you can only
select characters that are currently
available. The set of characters that is
available depends on those already entered
and the content of the destination memory.
When entering characters, the list entry 3
always displays a city that best matches the
characters already entered. COMAND
autoatically adds matching letters 3 to
those chracters 2 already entered by the
user.
For the steps of
Entering characters
R
Deleting an entry
R
69
Z