Removing bezel blanks
On some models, there may be bezel blanks covering the optical drive bays. You must remove the bezel blank
before installing an optical drive. To remove a bezel blank:
1.
Prepare the computer for disassembly
2.
Remove the access panel
3.
Remove the front bezel
4.
To remove a 5.25-inch optical drive bezel blank, press inward on the two tabs on the right side of the
blank (1), and then rotate the blank off the front bezel (2).
22
Chapter 4 Removal and replacement procedures
(Preparation for disassembly on page
(Access panel on page
18)
(Front bezel on page
19)
17)