ZyXEL Communications VES1724-56 User Manual page 93

Table 18 Remote CPE Configuration (continued)
LABEL
Wan
Queue
Filter
Lan
Protocol
Source/
Destination
Informatio
n
Priority
prtcl-type
Add/Apply
Port Config
Index
Speed
mnt
Console
Active
Admin
User
Layer2 Setting
IGMP
Snooping
Unknown
Multicast
Lan Setting
IP
DHCP
Disable
VES1724-56 User's Guide
DESCRIPTION
Specify the CPE's WAN connection (1~4) through which to forward the traffic that matches
this classification rule.
Specify a CPE's queue (1~4) that applies to this classification rule.
This section defines two sets of classification criteria (Set-1 and Set-2).
Specify which Ethernet port traffic of this classifier should come. Enter a number between 1 to
5 when the Virtual Port function is enabled or between 1 to 3 when it is disabled in the device.
Specify the protocol (1:TCP/UDP, 2:TCP, 3:UDP or 4:ICMP) for the service type.
IP: Enter the source/destination IP address in dotted decimal notation.
Mask: Enter the source/destination subnet mask.
Mac: Enter the source/destination MAC address of the packet.
Mac Mask: Type the mask for the specified MAC address to determine which bits a packet's
MAC address should match. Enter "f" for each bit of the specified source MAC address that the
traffic's MAC address should match. Enter "0" for the bit(s) of the matched traffic's MAC
address, which can be of any hexadecimal character(s). For example, if you set the MAC
address to 00:13:49:00:00:00 and the mask to ff:ff:ff:00:00:00, a packet with a MAC
address of 00:13:49:12:34:56 matches this criteria.
Start Port: Enter the starting port number of the source/destination.
End Port: Enter the ending port number of the source/destination.
Enter a priority level (0~7). "0" is the lowest priority level and "7" is the highest.
Enter a protocol type (0600~FFFF).
Click this to add a new classification rule or apply the changes for an existing classification
rule on the Switch.
Specify a LAN port (1~4) on the CPE device.
Specify a number (1:auto, 2:10H, 3:10F, 4:100H, 5:100F) for the port speed and duplex
setting where H represents half-duplex and F represents full-duplex.
Use this section to configure the console port settings for the CPE device.
Select Enable to activate multiple user login (using the Admin and User accounts) through
the CPE's console port. Otherwise, select Disable to deactivate it.
Enter a new admin password (up to 16 characters) for the CPE device. Note that as you type
a password, the screen displays a (*) for each character you type.
Enter a new user password (up to 16 characters) for the CPE device. Note that as you type a
password, the screen displays a (*) for each character you type.
Select Enable to turn IGMP Snooping on in the CPE device or select Disable to turn it off.
Select Block to have the CPE device block all unknown multicast packets from the WAN or
select Forward to broadcast unknown multicast packets from the WAN to all LAN ports.
Enter the LAN IP address and subnet mask in the IP and Mask fields if you want to change
them for the CPE device.
Select this if you do NOT want to configure this setting for the CPE device. Clear this to have
the Switch send this setting changes to the CPE after you click Apply.
Chapter 8 Basic Setting
93