ZyXEL Communications VES1724-56 User Manual page 289

Click Advanced Application > PPPoE IA Configuration in the navigation panel, and then click
the VLAN link to display the screen as shown.
Figure 174 Advanced Application > PPPoE IA Configuration > VLAN
The following table describes the labels in this screen.
Table 130 Advanced Application > PPPoE IA Configuration > VLAN
LABEL
VID
Append Circuit
ID
Circuit ID
Information
Append Remote
ID
Remote ID
Information
Add
Cancel
Clear
VID
VES1724-56 User's Guide
DESCRIPTION
Enter the ID number of the VLAN to which PPPoE IA settings you configure here apply.
Select this option to have the Switch add the user-defined identifier string (specified in the
Circuit ID Information field) to PADI or PADR packets from PPPoE clients.
If you leave this option unselected and do not configure any Circuit ID string (using CLI
commands) on the Switch, the Switch will use its host name.
Enter a string of up to 63 ASCII characters that the Switch adds into the Agent Circuit ID
sub-option for PPPoE discovery packets with the specified VLAN tag. Spaces are allowed.
Otherwise, select the second option to have the Switch use its host name.
Select this option to have the Switch add the user-defined identifier string (specified in the
Remote ID Information field) to PADI or PADR packets from PPPoE clients.
Select the first option and enter a string of up to 63 ASCII characters that the Switch adds
into the Agent Remote ID sub-option for PPPoE discovery packets with the specified VLAN
tag. Spaces are allowed. If you do not specify a string here, the Switch automatically uses
the PPPoE client's MAC address.
Otherwise, select the second option to have the Switch use the name of the port on which
the PPPoE discovery packets are received.
Click Add to insert a new VLAN-specific PPPoE IA entry to the Switch's run-time memory.
The Switch loses these changes if it is turned off or loses power, so use the Save link on the
top navigation panel to save your changes to the non-volatile memory when you are done
configuring.
Click Cancel to reset the above fields to your previous configuration.
Click Clear to set the above fields back to the factory defaults.
This field displays the ID number of the VLAN group to which the PPPoE IA settings apply.
Chapter 32 PPPoE IA
289