ZyXEL Communications VES1724-56 User Manual page 273

You have to create a CFM MD first before you create an MA.
Note:
Figure 163 CFM MA
The following table describes the labels in this screen.
Table 118 CFM MA
LABEL
MD level
MA Name
MA Vlan ID
CFM Enable
Port
Active
Name
MP Type
MEP ID
Add
Cancel
Clear
Index
MA Name
VES1724-56 User's Guide
DESCRIPTION
Select a level (0-7) you want to create an MA under.
Note: You have to create an MD first by clicking the CFM MD link.
Type a descriptive name (up to 40 printable ASCII characters) for this MA. This is for
identification purpose.
Type a VLAN ID (0-4096) for this MA.
Note: Make sure the VLAN ID has existed before you use it for the MA VLAN ID.
Select this to activate the CFM.
This field displays the port number.
Select this to activate a port in this MA.
This field displays the MA name.
Select a port type such as MEP (Maintenance End Point) or MIP (Maintenance Intermediate
Point). Or leave it as default (None).
Enter an ID number (1-8191) for this MEP port. Each MEP port needs a unique ID number within
an MD. The MEP ID is to identify an MEP port used when you create a CFM action. See
45.1 on page 354
.
Click Add to add the settings as a new entry in the summary table below.
Click Cancel to reset the fields.
Click Clear to start configuring the screen again.
This field displays the index number for the record in this summary table.
This field displays the descriptive name of the MA.
Chapter 28 CFM
Section
273