Installing The Reader Heater - Canon iR2030 Series Service Manual

Mount the stream reading glass with the notch [1] of the sheet
material affixed to the glass is at the front left.
3) Remove the jump board [2].
- Screw [1], 1pc.
[1]
[2]
4) Remove the stay [2].
- Screws [1], 2pcs.
[2]
[1]
F-2-80
F-2-81
[1]
F-2-82

2.7.5 Installing the Reader Heater

1) Pull the front side [1] of the drive belt in the direction of the arrow to move
the contact sensor [2] to the vicinity of center.
Do not touch the top surface of the contact sensor.
[1]
2) Install the heater base [2].
- Screw [1], 1 pc.
3) Install the reader heater [3] on the header base [2].
- Screw [4], 1 pc.
2) Install the heater base [2] using a screw [1].
3) Install the reader heater [3] on the header base [2] using a screw [4].
Connect the connector [5] of the heater. Install the wire saddle [6] and
route the cable [7].
4) Install the wire saddle [6] and route the cable [7].
5) Connect the connector [5] of the heater.
[1]
[2]
Chapter 2
[2]
F-2-83
[5] [6] [7] [4]
[3]
F-2-84
0017-5561
2-23