Chapter 2
5) Remove the upper-right cover [1].
- RS tightening screw (M3 x 8)[2], 1 pc.
6) Remove the delivery tray [1].
- RS tightening screws (M3 x 8)[2], 2 pcs.
When detaching the derivery tray, be careful not to damage the paper
holder [3].
[3]
[2]
MEMO:
When the Finisher-U2 is connected, detach the tray unit of finisher refer
to the service manual of the Finisher-U2.
2-16
[1]
[2]
F-2-60
[1]
7) Using a nipper or the like, cut out the face plate [2] (used to install a heater
switch) on the lower-right cover [1].
2.6.3 Installing the Heater PCB
1) Install the heater PCB unit [2].
- Supplied TP screws (M3x8) [1], 2pcs.
2) Install the heater switch [3] on the right side panel.
Install the heater switch with the OFF position on the left
and the ON position on the right just like the main power
switch.
[2]
[1]
F-2-61
[2]
[1]
[3]
F-2-62
0017-5556