16) Affix the two supplied harness covers (bases) at the right rear of the ma-
chine with it aligned with the bottom line of the reader.
17) Affix the supplied harness cover (base) [1] at the back of the machine
with it aligned with the bottom line of the reader.
18) Connect the connector of the repeating harness B [1] to the connector
J317 [2] on the image processor PCB.
[2]
19) Secure the repeating harness B clamp [2].
- Supplied binding screw (M4x6) [1], 1pc.
[2]
[1]
F-2-49
[1]
F-2-50
[1]
F-2-51
[1]
F-2-52
20) Using the three harness covers (lids) [2], secure the repeating harness B
[1] to the harness covers (bases).
21) Using a nipper, remove the precut portion [1] of the rear cover as shown
below.
22) Attach the rear cover with the repeating harness B routed through the cut
portion [1] of the rear cover.
2.5.4 Registering the Card IDs
After installing the card reader-E1, register the card
numbers to be used in the service mode of the host machine.
If they are not registered, cards will not be recognized when
inserted.
Chapter 2
[2]
[1]
F-2-53
[1]
F-2-54
[1]
F-2-55
0017-5553
2-13