Power Cable Connection - Oki MB461 Maintenance Manual

Oki Data CONFIDENTIAL

3.5.2 Power Cable Connection

Conditions for Power Supplies
• Observe the following conditions:
Alternate Current (AC) : 110 ~127VAC(Range 99~140VAC)/220~240VAC(Range
198~264VAC)
Power Supply Frequency : 50Hz or 60Hz±2%
• Use a voltage regulator when the power supply is not stable.
• The maximum power consumption of this MFP is 950W. Confirm that the power
supply has sufficient extra capacity.
Warning
It may expose you to electric shocks or cause a fire.
• Never fail to switch off the power supply at the time of connection or removal of the
electric cord and earth cable.
• Always connect the earth cable to the earth terminal equipped only for that purpose.
Never connect the earth cable with water pipe, gas pipe, telephone cable earth
terminal, lightening rod, etc.
• Always grasp the power plug at the time of connection and removal of the electric
cord.
• Always make sure that the electric plug is inserted fully into the outlet.
• Do not connect or disconnect the electric plug with the wet hand.
• Do not install the electric cord at the place liable to be stepped on and do not put
things on the electric cord.
• Do not bundle up or tie up the electric cord
• Do not use the damaged electric cord.
• Do not put many loads on one electric outlet.
• Do not connect this MFP to the same outlet with other electric machines. Particularly,
erroneous operation may occur by electric noise when the same outlet is shared by
the air conditioner, duplicator, shredder, etc. at the same time. When the same outlet
had to be used, use a noise filter or noise cut transformer on the market.
• Use the attached electric cord only.
• Do not use an extension cord. Use the cord of over rating 15A if you had to use one.
• When you use the extension cord, the MFP may not operate normally due to the drop
of AC voltage.
• Do not shut down the power supply or remove the power plug while printing.
• Disconnect the power cord when the MFP would not be used for some long while due
to consecutive holidays or journey.
As to the connection of the electric cord and earth cable, explain fully to the customer
showing the User's Manual.
44871001TH Rev.6
Turning On the Machine
(1) Plug the AC cord into the AC power socket of the machine.
(2) Plug the AC cord into the electric socket.
(3) Check that no documents are on the document glass or ADF, and the ADF cover is
closed.
(4) Hold down the power switch for about a second to turn on the power.
The copy standby screen is displayed after the machine became ready status.
Note! Turn the power off, and when turning the power back on again, push the
power switch after waiting for a few seconds.
3. MFP INSTALLATION
3-14