Led Head; Frame-Assy-Tr - Oki MB461 Maintenance Manual

Oki Data CONFIDENTIAL

4.2.10 LED Head

(1) Open the Stacker Cover.
(2) Remove the ID UNIT.
(3) Disengage the tab of the Holder-Head from the stacker cover by using a flat-head
screwdriver or something.
(4) Pull the Holder-Head toward you as illustrated below.
(5) Open the Holder-Head by arrow direction and then remove the hook. remove the
LED Head .
(6) Remove the FFC cable from the connector of LED Head
(7) Installing is performed by the reverse procedure with removing.
Note! Beware of not to touch or press the SLA parts of LED Head directly.
44871001TH Rev.6
.
Holder-Head
Hook
FFC cable

4.2.11 Frame-Assy-TR

(1) Open the Stacker Cover.
(2) Remove the ID UNIT.
(3) Take the Frame-Assy-TR out of the printer.
(4) Disengage the latches of Bearing-TR
(5) Hold the Bearing-TR on the both side, and then lift up the Roller-Transfer
(At this moment, Gear-TR
(6) Installing is performed by the inverse procedure with removing.
Note! (to assemble)
1. While installing, pay attention to the up-and-down direction of Bearing-TR
2. Operating carefully, not to touch Roller-Transfer
3. Be careful not to fit each Bearing-TR
inclined.
Spring
Frame-Assy-TR
4.REPLACEMENT OF PARTS
on both ends.
is also removed.)
surface.
to the Frame-Assy-TR with their springs
Spring
Latch
.
.
4-31