Table of Contents
Advertisement
Using the Matrix Switcher Control Software
Many items found in the Matrix Switchers Control Program are also accessible front panel
controls (see the"Operation" section) and under SIS control (see the
Guide" section). The Matrix Switcher + Help Program provides information on settings and
on how to use the control program, itself.
1.
To run the Matrix Switchers Control Program, click
Electronics
The
Comm Port Selection
Figure 32.
2.
Choose either the comm port that is connected to the RS-232 ports of the matrix
switcher,
If you selected a comm port, check the baud rate displayed in the comm port
z
z
selection window. Available rates are 9600, 19200, 38400, and 115200. The
default is 9600.
NOTE:
Click
(see
attached matrix. Proceed to step 4.
If you selected
z
z
If you selected
z
z
>
Matrix Switchers
window (see figure 32) appears.
Comm Port Selection Window
, or
.
IP [LAN]
Emulate
If you need to change the baud rate, click the
button and double-click the desired baud rate.
. The Extron Matrix Switchers Control Program window
OK
figure 34
and
figure
35) appears, displaying the current configuration of the
, click
IP [LAN]
, click
Emulate
MPX 866 A Media Presentation Matrix Switcher • HTML Operation
>
Start
Programs
>
MATRIX Switcher + Control Pgm
Baud
and proceed to step 3.
OK
and see
"Using Emulation
OK
"Programming
>
Extron
.
Mode" on page 93.
76
Advertisement
Table of Contents
