Comtech EF Data SLM-7650 Installation And Operation Manual page 175

Comtech ef data satellite modem installation and operation manual
Table of Contents

Advertisement

SLM-7650 Satellite Modem
Remote Control Specifications
A.17
General Status, Performance
Raw BER
Command:
Response:
Corrected
Command:
BER
Response:
Interface
Command:
Read Error
Response:
Status
<add/RBER_'cr'
>add/RBER_xm.mE-ee'cr''lf']
<add/CBER_'cr'
>add/CBER_xm.mE-ee'cr''lf']
<add/IRES_'cr'
>add/IRES_tttt_xn.nE-ee'cr''lf']
Where:
x = < or > (data modifier to indicate that the error rate is
less than or greater than the returned value).
m.m = 1.0 to 9.9 (error rate mantissa).
ee = 1 to 99 (error rate exponent).
Notes:
1. The 'x' (< or >) parameter is only returned if the error
rate has exceeded the computational resolution of the
system.
2. 'No Data' is returned if the error rate cannot be
calculated.
3. 'Sampling' is returned if not enough data is currently
available to calculate the error rate.
Where:
x = < or > (data modifier to indicate that the error rate is
less than or greater than the returned value).
m.m = 1.0 to 9.9 (error rate mantissa).
ee = 1 to 99 (error rate exponent).
Notes:
1. The 'x' (< or >) parameter is only returned if the error
rate has exceeded the computational resolution of the
system.
2. 'No Data' is returned if the error rate cannot be
calculated.
3. 'Sampling' is returned if not enough data is currently
available to calculate the error rate.
Where:
tttttt = 2047 or MIL188 (indicates type of error being read).
x = < or > (data modifier to indicate that the error rate is
less than or greater than the returned value).
m.m = 1.0 to 9.9 (error rate mantissa).
ee = 1 to 99 (error rate exponent).
This command returns 2047 or MIL188 error rate. The 'IRE_'
configuration command is used to select reading of 2047 or
MIL188 errors.
Notes:
1. The 'x' (< or >) parameter is only returned if the error
rate has exceeded the computational resolution of the
system.
2. 'No Data' is returned if the error rate cannot be
calculated.
3. 'Sampling' is returned if not enough data is currently
available to calculate the error rate.
A–33
Revision 4
MN/SLM7650.IOM

Advertisement

Table of Contents
loading

Table of Contents