Installation Overview; Stage 1: Installing The Receiver Base And Housing - Extron electronics VoiceLift User Manual

Installation Overview

The installation procedures are outlined in this section. For detailed descriptions and
illustrations of these procedures, see the VoiceLift System Installation Guide.
NOTE: Observe all local and national building and safety codes to ensure that the

Stage 1: Installing the Receiver Base and Housing

Stage 1a: Installing in a drop ceiling
(See the diagram at right.)
1.
2.
3.
4.
5.
Stage 1b: Installing in a junction box
(See the diagram at right.)
1.
2.
3.
installation meets all regulatory codes.
Cut a hole 2 to 3 inches (51 to 76 mm) in diameter in the
ceiling tile in which the receiver will be mounted.
Align the knockout in the receiver housing back plate with
the hole in the ceiling tile.
Insert the ceiling bracket screw through the back plate and
the hole in the ceiling.
If needed, attach a conduit to the back plate.
Attach the Z-bracket to the end of the screw on the back
side of the ceiling tile. Replace the ceiling tile.
Install the junction or ceiling box (not included).
Attach the receiver housing to the junction box.
If needed, attach a conduit to the junction box.
VoiceLift System with PVS 405D • Installing the Receiver (Overview) 36