Extron electronics VoiceLift User Manual page 21

To charge the microphone using the charging station:
1.
Turn off the microphone by sliding the power switch to Off.
NOTE: The microphone should be turned off before charging. However, if it is
inadvertently left on, the microphone continues to charge, but at a slower rate. If
the microphone is on when placed in the charger, its power LED lights red.
r o n
E x
t r o
n
VLP 202
Figure 11. Sliding the Microphone Power Switch to Off
2. Plug the wall charger into a 110-130 VAC (U.S.) or XX-240 VAC (international) power
source.
3. Connect the charger cable to the charging station power jack.
Figure 12. Wall Charger Cable and Charging Station Power Jack
4. Place the microphone in one of the slots in the charging station, with the charging
contacts on the bottom of the microphone facing down. Charge until the Pwr LED
lights green (this takes up to 5 hours).
E x
t r o
n
Figure 13. Charging Contacts on the Microphones
VoiceLift System with PVS 405D • Features and Operation
Charging Contacts on Pendant
Microphone Bottom Panel
Charging Contacts on Handheld
Microphone Bottom Panel
VLH 102
15