Table of Contents
Advertisement
Hardware Specifications
Hardware
• When packing, perform the unpacking procedure on "Unpacking" (page 13)
in Chapter 2 in reverse. To protect the library against damage caused by shock
or vibration, be sure to install the transport lock and transport screw before
packing.
• Take out all the cartridges set in the library. If the cartridges cannot be taken
out by operating the control buttons, refer to "The cartridges cannot be taken
out." (page 84) in the "Troubleshooting" section to take out the cartridges.
• In order to turn off the power to the AIT library, first press the front power
standby switch, then press the power switch on the rear. When the power
standby switch is pressed, the internal mechanism moves to the appointed
position, then the power enters the standby state.
• Remove all the cables such as the power cable, the SCSI cable, the terminator
and the network cable.
AIT Drive
LIB-162/A1: SDX-400C/L (1)ACY-DR162/A1R
LIB-162/A2: SDX-500C/L (1)ACY-DR162/A2R
LIB-162/A3: SDX-700C/L (1)ACY-DR162/A3R
Hot swap is possible
Number of drives that can be installed
Two drives (Standard is one)
Number of cartridges that can be set
Maximum of 16 volumes
Data transfer rate
AIT-3
AIT-2
AIT-1
21 characters × 7 rows
LCD panel
LED
Two lamps
External connectors
Ultra 2
Wide LVD SCSI (4)
Ethernet
10Base-T (RJ-45) (1)
RS232C
D-sub 9 pin (3, they are unused.)
Operating environment
Temperature: 10ºC to 35ºC
Density: 20% to 80%
(Avoid condensation)
Power
AC100 V to 120 V +10%/-10% (50/60Hz)
AC200 V to 240 V +8%/-10% (50/60Hz)
Power consumption
100W Typical
External Dimension
430 (W) × 88 (H) × 680 (D) mm
(16.9 (W) × 3.5 (H) × 25.2 (D) in.)
Mass
17.8 kg (39.2 lb.) (One AIT drive is installed.)
Native
DC
12MB/s
24MB/s
6MB/s
12MB/s
4MB/s
8MB/s
85
Appendix
Advertisement
Table of Contents
