Related Manuals for Sony LIB-162
Summary of Contents for Sony LIB-162
- Page 1 4-662-835-14(2) AIT Library Quick Start Guide ______________________________________ LIB-162...
- Page 2 INFORMATION You are cautioned that any changes or modifications not expressly approved in this manual could void your authority to operate this equipment. WARNING To prevent fire or shock hazard, do not expose the unit to rain or moisture. To avoid electrical shock, do not open the cabinet. Refer servicing to qualified personnel only. Caution The mains plug on this equipment must be used to disconnect mains power.
- Page 3 Declaration of Conformity Trade Name: SONY Model No.: LIB-162 Responsible Party: Sony Electronics Inc. Address: 680 Kinderkamack Road, Oradell, NJ 07649 USA Tel: 201-930-6972 This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation.
-
Page 4: Table Of Contents
What’s next? ............9 Trademarks • Advanced Intelligent Tape is a trademark of Sony Corporation in this country, other countries, or both. • Other product names are trademarks or registered trademarks of their respective owners in this country, other countries, or both. -
Page 5: Unpacking
Bottom equipment as described in this manual, please read the Operating Instructions (PDF) on the CD-ROM and make necessary settings. • LIB-162 main unit (1) • Power cable (1) • SCSI terminator (1) • Quick Start Guide (1) • CD-ROM (this manual) (1) •... -
Page 6: Installing The Ait Library
Installing the AIT library Connecting the Power Cable The library weighs about 18 kg (39.7 lb.) and has the following dimensions. Before installing the library, make sure that the surface on which you are placing it is Confirm that the power switch on the rear of the large and strong enough. -
Page 7: Connecting To The Host Computer
The manner in which it is attached varies with the Connecting to the Host number of internal drives. Computer When there is only one standard internal AIT drive (AIT drive is not added): 1 Use a SCSI cable (sold at stores) to connect the Connect the AIT library and the host computer with a AIT library to the host computer. -
Page 8: Turning The Power On/Off
If you want to change the date and time, press the Turning the Power On/ [ENTER] button. If you do not want to make changes, press the [CANCEL] button. Jan/01/2001 12:00:50 Set the Date and Time Turn the Power On if necessary Turn on the AIT library power, then turn on the host [ENTER] to set... -
Page 9: What's Next
Turn the Power Off What’s next? Press the power standby switch on the front panel at least 3 seconds. Read the Operating Instructions, install cartridges, make network connections as necessary, then make settings When the power standby switch is pressed, the required to use the library. - Page 10 For information about the AIT library, refer to your reseller. Sony Corporation...