Table of Contents
Advertisement
Connecting a Network Cable
7
When the "Gateway" setting flashes, use the V button, the v button, the B
button and the b button to set the IP address for the default gateway, then
press the [ENTER] button.
If no setting has been made, a flashing rectangle appears.
8
When the "DHCP" setting flashes, use the V and v buttons to select either
"YES" or "NO", then press the [ENTER] button.
• Select "YES" to use the IP address assigned to the DHCP server. Then
proceed to step 12.
• Select "NO" to use the fixed IP address. Then proceed to step 10.
9
When the "IP Address" setting flashes, use the V button, the v button, the
B button and the b button to set the IP Address, then press the [ENTER]
button.
If no setting has been made, a flashing rectangle appears.
10
When the "Subnet Mask" setting flashes, use the V button, the v button, the
B button and the b button to set the subnet mask, then press the [ENTER]
button.
If no setting has been made, a flashing rectangle appears.
11
When "[ENTER] to activate"
appears, press the [ENTER] button.
Each of the items of the network is
now set. The display returns to
"Network".
12
Press the [CANCEL] button to return to the status display.
13
Press the power standby switch on the front panel to set the power of the
library to the standby state.
After setting the network and setting the AIT library power to the standby state,
connect a network cable.
1
Connect a network cable from the hub to the Ethernet connector on the
library.
2
Turn on the library power.
Network
DHCP YES
IP Address
192.168.0.1
Subnet Mask
255.255.255.0
[ENTER] to activate
Chapter 2 Installation
12:34
30
Advertisement
Table of Contents
