Message Alert Tone - AT&T TL96273 Complete User's Manual

Answering system
Answering system settings

Message alert tone

When the message alert tone is set to On, and there is at least one new
message, the telephone base beeps every 10 seconds. The tone stops when all
new messages have been reviewed. By default, the message alert tone setting
is Off.
To change the setting:
Using a cordless handset or the telephone base:
MENU
1. Press
2. Press or
CID
SELECT .
3. Press or
CID
SELECT .
4. Press or
CID
SELECT .
5. Press or
CID
press SELECT. You hear a confirmation tone.
NOTES:
• To temporarily turn off the message alert tone, see page 104.
• The message alert tone beeps only if all the conditions below are met.
– Answering system is on.
– Message alert tone setting is on.
– There are new messages.
in idle mode.
to highlight Answering sys, then press
DIR
to highlight Ans sys setup, then press
DIR
to highlight Msg alert tone, then press
DIR
to choose between On and Off, then
DIR
104
ANS SYS SETUP
# of rings
Remote code
Msg alert tone
BACK SELECT
MSG ALERT TONE
On
Off
BACK SELECT