AT&T TL96273 Complete User's Manual page 78

Multiple handset
Push-to-talk (PTT)
Using the telephone base:
There are a few ways to begin a PTT call to a single handset. When the
telephone base is not in use:
• If you have one handset, press and hold PTT in idle mode.
-OR-
• If you have more than one handset, press PTT in idle mode. Use the
dialing keys to enter a handset number (1-9 for handsets 1-9, TONE
and 0 for handset 10, TONE
and 2 for handset 12), or press
handset then press
2. Your handset displays Connecting to HANDSET X... (HANDSET
represents the handset name, X represents the destination handset
number) for a few seconds. When the connection is made, both the
telephone base and the destination handset display Press and hold
[PTT] to talk and beep once.
3. Press and hold PTT. A chirp indicates your microphone is on. Speak
towards the telephone base. Your voice is broadcast to the destination
handset. While you are speaking, the handset displays PTT To HANDSET
X (X represents the destination handset number).
4. Release PTT after speaking. Both devices beep once again and the screens
show Press and hold [PTT] to talk, then you can press and hold PTT to
continue speaking or the destination handsets can respond (see Answer a
PTT call on page 75).
5. To end the PTT call, press
Push to talk Ended for a few seconds.
-OR-
Place the handset in the telephone base or charger to end the PTT call.
The telephone base shows Push to talk Ended for a few seconds.
NOTE: After PTT is released, the PTT call remains open for a short time. If no one presses
PTT within 10 seconds, the PTT call ends automatically.
and 1 for handset 11 or TONE
CID
SELECT or PTT to create the push-to-talk session.
CANCEL or END. The telephone base shows
72
or to scroll to the desired
DIR