AT&T TL96273 Complete User's Manual page 140

Appendix
Troubleshooting
The handset registration is unsuccessful.
Follow the steps below to register the handset again.
1. Make sure the handset is out of the telephone base or charger and shows
To register, see user manual before you begin registration.
2. Place the handset you wish to register on the telephone base cradle. The
handset displays Registering... Please wait on the handset and the red
IN USE light on the telephone base turns on. It takes about 90 seconds
to complete the registration process. The handset displays HANDSET X
Registered (X represents the registered handset number). The IN USE light
turns off and the handset beeps when registration is completed.
Adding and registering handsets/headsets
Refer to the
116-117 for details.
Out of range OR Base no power appears on my cordless handset.
• Ensure that the telephone base is powered up.
• Place the cordless handset in the telephone base for one minute to allow
the cordless handset and base to synchronize.
• Move the cordless handset closer to the telephone base. You might have
moved out of range.
• Reset the telephone base. Unplug the electrical power. Wait for 15 seconds,
then plug it back in. Allow up to one minute for the cordless handset and
telephone base to reset.
• Other electronic products such as HAM radios and other DECT phones can
cause interference to your cordless telephone. Try installing your telephone
as far away as possible from these types of electronic devices.
134
section on pages