AT&T TL96273 Complete User's Manual page 27

Bluetooth
Bluetooth setup
6. Set your headset to discoverable mode (refer to the
user's manual of your headset), then press NEXT. The
screen displays Searching for Bluetooth headsets...
• All devices that are connected to the telephone base
are temporarily disconnected.
7. When the screen displays the found devices, press
or
CID DIR
press SELECT.
• Enter the PIN of your headset if required. The PIN
for most Bluetooth devices is 0000 (refer to the
user's manual of your headset). Press
continue.
The screen displays Adding Headset A when the base is
connecting to your headset.
When a device is successfully connected, the telephone
base displays Headset A is added and connected to base
and the corresponding status icon ( 2) displays on the
handset. You hear a confirmation tone. The CELL 2/HEADSET
telephone base turns on.
If you have trouble pairing your headset, it may not be compatible with
your TL96273/TL96323/TL96373/TL96423/TL96473. Check the Bluetooth
compatibility list at
NOTES:
• The pairing process may take up to one minute. If the pairing process fails, try again.
• When a connected headset is charging, it may disconnect from the telephone base and the
corresponding light on the telephone base (CELL 2/HEADSET ) turns off. For some headset
models, you may need to turn on the headset and reconnect it to the telephone base again.
to highlight your headset if necessary, then
www.telephones.att.com/bluetooth
NEXT to
21
Searching for
Bluetooth
headsets...
FOUND DEVICES
Headset A
Headset B
BACK SELECT
Adding
Headset A
Headset A
is added
and connected
to base.
light on the
.