Message Alert Tone - AT&T CL82115 User Manual

Answering system
Answering system settings

Message alert tone

When the message alert tone is set to On, and there is at least
one new message, the telephone base beeps every ten seconds. By
default, the message alert tone is set to off.
There is no audible alert at the handset.
To change the setting:
1. When the handset is in idle mode, press MENU/
to enter the main menu.
SELECT
2. Press or
CID DIR
then press /SELECT.
MENU
3. Press or
CID DIR
then press /SELECT.
MENU
4. Press or
CID DIR
then press /SELECT.
MENU
5. Press or
CID DIR
6. Press /SELECT to save the setting. You hear a confirmation
MENU
tone.
NOTES:
• The message alert tone beeps only if all the conditions below are met:
- Answering system is on.
- Message alert tone setting is on.
- There are new messages.
• To temporarily turn off the message alert tone, see page 85.
to scroll to Answering sys,
to scroll to Ans sys setup,
to scroll to Msg alert tone,
to choose On or Off.
Remote code
>Msg alert tone
MSG ALERT TONE
>On