Table of Contents
Advertisement
Multiple handset use
Push-to-talk (PTT)
Make an outgoing call during PTT call
•
During a one-to-one PTT call, press
/SPEA�ER on your telephone base to get a dial tone. The PTT call
ends automatically.
•
During a one-to-group PTT call, press
handset or
ends automatically and you get a dial tone.
•
During a one-to-group PTT call, press
destination handsets or press
base. That device gets a dial tone. The PTT call continues for the rest of
the PTT participants.
End or leave a PTT call
For one-to-one PTT calls, both initiating and destination devices can end the
PTT call. For PTT calls to multiple devices, the initiating device can end the
PTT call. If any one of the destination devices leaves the PTT call, the call
continues until all participants or the initiator hangs up.
Press
OFF/
CANCEL
base. The screen shows Push to talk Ended.
-OR-
Place the handset in the telephone base or charger, then the handset
return to idle mode.
NOTE: After PUSH TO TAL� on the handset or PTT on the telephone base is released, the PTT
call remains open for a short time. If no one presses PUSH TO TAL� on the handset or PTT on
the telephone base within ten seconds, the PTT call ends automatically.
/SPEA�ER on the initiating telephone base. The PTT call
on the handset, or press CANCEL on the telephone
PHONE/
FLASH
PHONE/
PHONE/
/SPEA�ER on the destination telephone
57
on your handset or
on the initiating
FLASH
on any one of the
FLASH
Advertisement
Table of Contents
