Enabling Tcp/Ip; Configuring The Network Address Manually At The Control Panel - Xerox WorkCentre 7800 Series System Administrator Manual

IP
Internet Protocol (IP) is a protocol within the Internet Protocol Suite that manages the transmission of
messages from computer to computer.

Enabling TCP/IP

1. At the printer control panel, press the Machine Status button, then touch the Tools tab.
2. Touch Network Settings > TCP/IP Settings.
Touch TCPIP Enablement.
3.
4. Touch Enable for IPv4 or IPv6, then touch Close.
Note: By default, TCP/IP is enabled. If you disable TCP/IP, enable it at the printer control panel
before you access CentreWare Internet Services. For details, see
page 55.

Configuring the Network Address Manually at the Control Panel

1. At the printer control panel, press the Machine Status button, then touch the Tools tab.
Touch Network Settings > TCP/IP Settings.
2.
3. Touch Dynamic Addressing.
Touch Disabled, then touch OK.
4.
5. Touch IPv4, then type the IPv4 address, gateway address, and network mask. After each address,
touch OK.
6. When finished, touch OK.
IP on page 33 and
WorkCentre 7800 Series Multifunction Printer
System Administrator Guide
Network Connectivity
HTTP on
33