Installing The Vs-3 Voice Synthesizer Unit; Installing A Detachable Front Panel Kit (Dfk-3C/ Dfk-4C/ Dfk-7C) - Kenwood TM-G707 Instruction Manual

INSTALLING THE VS-3 VOICE SYNTHESIZER UNIT

ALWAYS SWITCH OFF THE POWER AND UNPLUG THE
CAUTION:
DC POWER CABLE FIRST.
1 Remove the five screws from the upper cover of the
transceiver.
2 Hold the VS-3 unit with the component side facing
inward, and insert the VS-3 connector into the
corresponding transceiver connector.
Component side
3 Replace the upper cover (5 screws).
INSTALLING OPTIONS
Viewed with the front
panel removed
INSTALLING A DETACHABLE FRONT PANEL KIT
(DFK-3C/ DFK-4C/ DFK-7C)
ALWAYS SWITCH OFF THE POWER AND UNPLUG THE
CAUTION:
DC POWER CABLE FIRST.
1 While sliding the spring-loaded release switch on the
rear of the front panel, remove the front panel from
the main unit.
• Be careful not to drop the front panel when releasing it.
Release switch
2 Hang the connector of the connectorized front panel
cable onto the catch on the main unit, and secure the
connector using the supplied screw.
• If the screw is loose, the transceiver may not function
properly.
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
67