Chapter 18 Cross-Band Operation - Kenwood TM-G707 Instruction Manual

1
This transceiver is capable of receiving signals on one
2
band and transmitting signals on another band. This
3
function, however, is neither Cross-band Repeater nor
Full Duplex. Cross-band Operation does not repeat
4
signals originating from one band, using another band,
5
and it does not receive and transmit signals
simultaneously. This function is useful, for example,
6
when joining in a group talk via a Cross-band Repeater.
7
Participants in a group talk need to set a receive and
8 transmit frequency on different bands so as not to miss
any conversations within the group.
9
Note: It is illegal to use Cross-band Repeater in some countries. Check
10
with your local regulations.
11
12
13
14
15
16
17
18
19
20
21
TM-G707
22
64
CROSS-BAND OPERATION
Cross-band
Repeater
TX: 146.500 MHz
RX: 443.500 MHz
1 Press [BAND] to select the band for transmitting.
2 Select the appropriate transmit frequency.
3 Press [BAND] to select another band.
• This band will be used for receiving.
4 Select the appropriate receive frequency.
5 Press [F] , [ ] to enter Cross-band Operation mode.
• A cross icon appears.
6 To exit Cross-band Operation mode, press [F] , [
again.
Note:
◆ You can use only 144 MHz and 430/ 440 MHz bands to perform
Cross-band operation.
◆
When in Cross-band Operation mode, pressing
receive and transmit band.
]
switches the
[BAND]