Front Panel - Kenwood TM-G707 Instruction Manual

FRONT PANEL

1
This section describes only the main functions of the front panel
Note:
controls and buttons. For the functions not described here, you will find
2
explanations in the appropriate sections of this manual.
3
4
5
6
7
8
9
10
q q q q q CALL button
11
Recalls the Call channel {page 31}. Also starts or
12
stops Call/VFO Scan {page 43} when in VFO mode,
or Call/Memory Scan {page 43} when in Memory
13
Recall mode.
14
w w w w w VFO button
15
Selects the VFO mode. In this mode you can change
16
the operating frequency, using the Tuning control or
17
Mic [UP]/ [DWN]. Also provides:
18
• VFO Scan start/stop to scan the entire VFO range
{page 40}.
19
• Program Scan start/stop to scan a programmed range of
20
frequencies {page 43}.
21
22
10
e e e e e MR button
Selects the Memory Recall mode {page 29}. In this
mode you can change memory channels, using the
Tuning control or Mic [UP]/ [DWN]. Also starts or
stops Memory Scan {page 40}.
r r r r r Tuning control
Selects:
• Operating frequencies when in VFO mode {page 16}.
• Memory channels when in Memory Recall mode
{page 29}.
• Menu Nos. when in Menu mode {page 19}.
This control is used for various other selections.
t t t t t MHz button
Selects the MHz mode. In this mode you can change
the operating frequency in 1 MHz steps or 10 MHz
steps {page 16}, using the Tuning control or Mic
[UP]/ [DWN]. Also starts or stops MHz Scan
{page 41}.