Table of Contents
Advertisement
DISPLAY DIMMER
1
■
Manual Dimmer Change
2
You can manually change the display illumination to
3
suit the lighting conditions where you are operating.
4
Press [DIM] to select from 5 levels, including OFF.
5
Note:
Selecting OFF automatically switches Auto Dimmer Change
6
ON.
7
■
Auto Dimmer Change
8
This function increases the display intensity one step
9
brighter for approximately 5 seconds when you press
a front panel button or Mic key, or turn the Tuning
10
control. No change occurs if you have selected the
11
brightest level.
12
1 Press [MNU] to enter Menu mode.
13
2 Select Menu No. 2 (A.DIM).
14
15
16
17
18
3 Press [OK] , then turn the Tuning control to switch
19
the function ON (or OFF).
20
4 Press [OK] again to complete the setting and exit
21
Menu mode.
22
56
BEEP VOLUME CHANGE
The transceiver beeps each time you press a front panel
button or Mic key. You can change the beep volume or
turn it off.
1 Press [MNU] to enter Menu mode.
2 Select Menu No. 16 (BEEP).
3 Press [OK] , then turn the Tuning control to select the
volume from levels 1 to 7 and OFF.
• The default is level 5.
4 Press [OK] again to complete the setting and exit
Menu mode.
DISPLAY DEMONSTRATION
By initiating this function, various pre-programmed
displays appear. You still can normally use the
transceiver in this mode. Pressing a front panel button
or Mic key, or turning the Tuning control restores the
operating display immediately. If there is no button/key
entry or Tuning control adjustment for approximately
12 seconds, the transceiver reverts back to
Demonstration mode.
Press [F] +[ ] to switch the function ON (or OFF).
Hide quick links:
Advertisement
Table of Contents
