Tone Unit; Voice Synthesizer Unit - Kenwood TR-851A Instruction Manual

7. OPTIONAL ACCESSORIES
7-1. MU-1 MODEM UNIT
Installing the MU-1 Modem unit.
Remove the top and bottom covers. Open the panel.
(See page 35.)
Install the Modem unit in the upper left corner of the
Control unit on the main chassis side with the two
furnished screws as shown. After the MU-1 is in-
stalled turn the DCL switch on to activate the DCL
system. (See the figure on page 36, for the location
of the switch.)
Connector wiing
Modem unt — .
Segiies x4
: Rel
~
Control unit
7-2. TU-7 TONE UNIT
Installing the TU-7 Tone unit.
Remove the top and bottom covers. Open the panel
(See page 35.)
Install the Tone unit in the upper left corner of the
Control unit on the main chassis side with the fur-
nished screw as shown.
Tone unit witing
ae
N
| ae)
\
Controt unit ~
8-pin cannector, white
7-3. TU-7 TONE UNIT AND MU-1 MODEM
UNIT
Installing the MU-1 Modem unit and TU-7 Tone unit
Install the Tone unit on top of the Modem unit shown
below. Fix the Modem unit to the Control unit with a
screw at the upper left and the furnished hexagonal
boss at the lower right. Attach the furnished cushion
on the Tone unit. install the Tone unit on the hex-
agonal boss on the Modem unit with a screw. Con-
nect the Modem unit after the physical installation
has been completed.)
After the MU-1 is installed turn the DCL switch on to
activate the DCL system. (See the figure on page 36
for the location of the switch.)
Control unt
Modem unit
ae ig feet
/
Hexaponal boss
Cushion j ~
7-4. VS-1 VOICE SYNTHESIZER UNIT
Installing the VS-1 Voice Synthesizer unit
Remove the bottom cover. Install the VS-1 voice
synthesizer unit on the tongues at the front left side
of the RX unit with two screws as shwon. Run the
wires inside.
Chassis
We
Panel -};
43