Selecting Priority Scan Method; Using Priority Scan - Kenwood TM-G707 Instruction Manual

Kenwood mobile transceiver instruction manual
Table of Contents

Advertisement

Selecting Priority Scan Method

This transceiver prepares the following two modes for
Priority Scan. Use mode B when you do not want
Priority Scan to disrupt your current QSO.
Mode A: Monitors the Priority channel every 3 seconds no
matter whether or not signals are being received
on the current operating frequency.
Mode B: Monitors the Priority channel every 3 seconds
only when no signals are present on the current
operating frequency.
1 Press [MNU] to enter Menu mode.
2 Select Menu No. 11 (PRI).
3 Press [OK] , then select mode A (default) or
mode B.
2
4 Press [OK] again to complete the setting and exit
Menu mode.
1

Using Priority Scan

1 Press [F] , [MNU] to start Priority Scan.
• "PRI" appears.
1
• When signals are received on the Priority channel, a
beep sounds and the Priority channel is recalled. In
addition, "PRI" blinks.
2 Press and hold Mic [PTT] to transmit on the
Priority channel and release Mic [PTT] to receive.
• Approximately 3 seconds after signals drop, Priority
Scan resumes.
3 To quit Priority Scan, press [F] , [MNU] again.
Note:
When signals are received on the Priority channel programmed
with CTCSS, the Priority channel is recalled; however, the
squelch does not open unless the signals contain the matching
CTCSS tone.
You can simultaneously use Priority Scan and any other type of
Scan; however Priority Scan does not function while the other
scan is being paused.
To monitor the current operating frequency while using Priority
Scan, press and hold the Mic PF key assigned the Monitor
function {page 51}. Release the key to resume Priority Scan.
1
2
3
4
2
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
45

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Tm-g707aTm-g707e

Table of Contents